Corrosion protection
Coating adhesion depends on the roughness profile. We supply the system that produces the required preparation grade and roughness repeatably.
Where our systems
are at work.
The component determines the system — not the other way round. A bridge makes different demands from a monopile or a casting.
Applications
Component and process
Eight typical tasks.
Bridge refurbishment
Work inside an enclosure, collect the blast media, carry the dust away — mobile, and without anything falling into the river or the traffic below.
Hydraulic steel structures
Sheet pile walls, lock gates, weir installations. Components that stand permanently in water and whose coating has to last accordingly.
Shipbuilding & shipyards
Large areas under time pressure. Recovery and reclamation cut the blast media requirement noticeably here, because the quantities are large.
Monopiles
Foundation tubes for offshore wind farms. Long tubes, high unit numbers, consistent surface quality over the full length.
Concrete repair
Remove the coating, expose the reinforcement, without weakening the load-bearing section — and the dust has to go.
Vessel construction & refurbishment
Inside as well as out. In closed vessels it is the extraction that decides whether work is permitted at all.
Structural steelwork
Sections, gusset plates, welded structures. Descaling and derusting before coating.
Not listed here, but just as much in use — pipeline refurbishment, power plant refurbishment, foundries, industrial cleaning, vehicle and vessel construction, and the defence industry.
Your component not among them?
Describe the material, the geometry and the surface you need — we will tell you which system fits.